Wake on PME refers to wake up events received through the PCI bus. Wake on LAN refers to wake up events received throughĪ 3-pin header cable. In both APM and ACPI computers, you may find settings for Wake on LAN* under the Power Control area and titled "Wake on LAN" and/or "Wake on PME". Check your BIOS settings to determine which mode you are operating in. Many ACPI computers can be configured to work in APM mode. You may need to configure various settings in the computer BIOS so that remote wake-up will work. Turning off the remote wake up capability on theĪdapter using the IBAUTIL utility reduces the power draw to around 50 milliamps They are keyed to fit either type ofģ.3 volt standby supply must be capable of supplying at least 0.2 amps for each Volt, but will work in a 5-volt slot also. See the documentation that came with your system for details on remote wake-up support. It does, however, support remote wake-up from standby from any slot. ![]() For example, the Intel Desktop Board D815EPEA2 only supports remote wake-up from a powered off (S5) state if the adapter is plugged into PCI slot 2. Motherboards will only support remote wake-up (or remote wake-up from S5 state) Response to ARP packets querying the first IP address in the list, usually the If multiple IP addresses are assigned to an adapter, the operating system may request to wake up on ARP patterns
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |